Do you need any advice? Call or send a WhatsApp message and you’ll receive an answer from one of our specialists within 5 minutes.
Double chamber peening pot
The double chamber peening pot is the heart of your machine. The top vessel automatically tops off the bottom vessel during the peening cycle. This enables guaranteed continuous peening.
- Low maintenance cost
- Low downtime
- High productivity
Exhaust valve SU 034
Filling cone SP 014
Main air valve SU 098
The double chamber peening pot system consists of two reservoirs, one above the other, each with a manifold. This system enables full-continuous peening. The top reservoir is used for continuously feeding the bottom reservoir, during the peening cycle. A level indicator, positioned in the bottom reservoir activates the top reservoir. Just below the bottom reservoir of the peening machine, we will install the pinch valves and media dosages valve (closed loop controlled).
A main air valve is installed on the bottom reservoir manifold, which is connected to the so-called “mixing tube”. Each connection is fitted with a non-return valve. Each reservoir is pressurised and is connected to each other by steel pipes and creates a separate air system in the double chamber peening machine.
The inlet of this air system has a 2″ main air valve and can be opened from the HMI control panel allowing the air under pressure into the double chamber peening-machine.
Close to this main air valve, a remote controlled reducing valve (closed loop controlled) is fitted which can be adjusted from the HMI control panel. Both reservoirs have a filling cone, which is opened and closed by a pneumatic cylinder. Control of the cones occurs automatically from the control panel with a feed back to a level indicator.
In accordance with the European Directive on pressure vessels 2014/68/EU and resolution Stable. 339 dated January 1st 2002, all pressure vessels should be certified by a Notified Body. Straaltechniek International B.V. delivers you these vessels i.a.w. these regulations, which are certified by Det Norske Veritas, and has also taken care of testing the applicable components. Straaltechniek International B.V. therefore delivers a peening pot as complete equipment, which complies with the European rules.
Why would you choose for straaltechniek?
Straaltechniek International is one of the few companies worldwide that both design and manufactures automated shot peening & high-end blasting machines. Straaltechniek International is very flexible in the individualised, tailor-made and bespoke configuration of machines and will always do its utmost to adapt a machine to fulfil all of the customer’s requirements.