The HMI full colour touch screen control panel provides all programming features and visualisation of all set- and actual peening parameters. Different menus can be selected to enable the operator to overview the entire process data. The touch screen control panel is compact and can be either wall mounted or standing on the floor. The USB interface or direct network connection facilitates data transmission.

Control and monitoring of the media flow rate is done by using a MagnaValves® and is a closed-loop process. This Magna valve is a normally closed magnetic valve and includes a built-in sensor for accurate measurement of flow rate. Used with our specially developed closed-loop software (no separate controller needed), the Magna valve will provide accurate and repeatable flow rates.

The valve construction includes a permanent magnet for normally closed operation and an electromagnet for controlling media flow rates. By regulating the voltage to the electromagnet, any desired flow rate may be achieved. When power is off, the valve will hold the media due to the permanent magnet.

To guarantee the media flow is within the minimum and maximum limits, alarm scales can be adjusted on the operator screen in the central switch board e.g. 5% deviation gives a visual alarm and 10% deviation is shutdown of application.

The 700-24 MagnaValve® is a normally closed valve that regulates the flow of non-ferrous media. The MagnaValve’s built-in sensor measures flow rate and, together with our specially developed software (no separate controller needed) provides accurate and repeatable flow rates. Ceramic bead and glass bead can be used in this valve. Other non-ferrous materials, such as Aluminum Oxide (AlOx), may also be used by special arrangement.

To guarantee the media flow is within the minimum and maximum limits, alarm scales can be adjusted on the operator screen in the central switch board e.g. 5% deviation gives a visual alarm and 10% deviation is shutdown of application.

The air pressure (= working pressure) can be adjusted on the HMI operator screen. This operator screen is connected to the main proportional electronic controlled reducing valve. This valve adjusts and monitors the air flow rate continuously.

To guarantee the air pressure is within the minimum and maximum limits, alarm scales can be adjusted on the operator screen in the central switch board e.g. 5% deviation gives a visual alarm and 10% deviation is shutdown of application.

If you have any questions, don’t hesitate to reach out to one of our shot peening specialists.